Some problems in the use of automatic lock screw machine

Nowadays, automation products are becoming more and more popular. In recent years, many domestic manufacturers have begun to emerge as automation products. Many of them are manufacturers of “automatic lock screw machines”. Many manufacturers say that they are derived from foreign technologies or the introduction of foreign technologies, but they say it is white. In fact, it is to imitate foreign technology. The "automatic lock screw machine" does not have any major drawbacks in terms of design principles. However, many design manufacturers have neglected a problem when designing, that is, the quality of screws, large heads, partial heads, and frontal (burrs), etc. Is the killer of the automatic lock screw machine, they are deadly to the "automatic lock screw machine" type. At present, few domestic manufacturers dare to say that each batch of screws does not have a large head, a biased head, or a frontal (burr). Therefore, the domestic "automatic locking screw machine" is very unstable at work, "handheld automatic "Lock screw machine" is better, there are manual operations, problems can be dealt with in a timely manner, but fully automatic is not alright, no one has found a problem, it seems that high efficiency, if you count the maintenance time may not be better The "hand-held automatic lock screw machine"! Specifically, the "automatic lock screw machine" is the main drawback is the card machine, floating teeth (lock is not tight), flower head, these are caused by the quality of the screw is not good or Manufacturers to solve the screw quality is not good and change the size of the design caused by, for most screw machine manufacturers can not be solved, is dead! ! ! The other is the problems of the machine itself, such as the materials used, the technology and the brand used in the electronic parts, and these are not big problems because powerful manufacturers can solve this problem. Here we do not discuss. The card machine need not be explained by me. It must be understood by everyone. The so-called floating teeth and flower heads are caused by two reasons. The first is the design of the structure itself, the second is the screw machine manufacturers to solve the deformed screw and increase all screw machine channel, including electric batch nozzle, electric nose nozzle is too large diameter is the biggest cause of floating teeth, flower head ! Automation has been prevalent for many years in foreign countries. They can be said to be very mature in technology. It is very clear that the problem of “automatic lock screw machine” is easy to appear in the lock payment, so it is easy to prescribe the right medicine, can be big head, flat head, The front-end (brain) screws are screened so that the machine, floats, and flower heads are not affected by the quality of the screws! It can automatically filter, automatically feed, no floating teeth and flower head!