Human TGF-β ELISA Kit

Human TGF-β ELISA Kit For the quantitative in vitro determination of Human transforming growth factor β concentrations in serum - plasma - celiac fluid - tissue homogenate - body fluid FOR LABORATORY RESEARCH USE ONLY. NOT FOR USE IN DIAGNOSTIC PROCEDURES. This package insert must be ELISAENZYME LINKED IMMUNOSORBENT ASSAYINTENDED USE AND TEST PRINCIPLEThis TGF-β ELISA kit is intended Laboratory for Research use only and is not for use in diagnostic or therapeutic procedures. The Stop Solution changes the color from blue to yellow And the intensity of the color is measured at 450 nm using a spectrophotometer. In order to measure the concentration of TGF-β in the sample, the TGF-β ELISA Kit includes a set of calibration standards. The calibration standards are assayed at the same Time as the samples and allow the operator to produce a standard curve of Optical Density versus TGF-β concentration. The concentration of TGF-β in the samp Les is then determined by comparing the OD of the samples to the standard curve. SAMPLE COLLECTION AND STORAGESSerum - Use a serum separator tube and allow samples to clot for 2 hours at room temperature or overnight at 4°C before centrifugation for 20 minutes at approximately 2000 ×g. Remove serum and assay immediately or aliquot and store samples at -20°C. Avoid repeated freeze-thaw cyclesPlasma - Collect plasma using heparin as an anticoagulant. Centrifuge samples for 30 minutes at 2000×g at 2-8°C within 30 minutes Avoiding freeze-thaw cycles.Cell culture supernates, tissue homogenate and other biological fluids - Remove particulates by centrifugation and assay immediately or aliquot and store samples at -20°C. cycles.Note: The samples shoule be centrifugated dequately and no hemolysis or granule was allowed.MATERIALS REQUIRED BUT NOT SUPPLIED1. 37 °C incubator2. Standard microplate reader capable of measu Ring absorbance at 450 nm3. Precision pipettes, disposable pipette tips and Absorbent paper4. Distilled or deionized waterREAGENTS PROVIDED All reagents provided are stored at 2-8°C. Refer to the expiration date on the label. Name 96 determinations 48 determinationsMicroelisa stripplate 12* 8strips 12*4stripsStandard(6 vial) 0.5ml/vial 0.5ml/vialSample diluent 6.0ml 3.0mlHRP-Conjugate reagent 10.0ml 5.0ml20X Wash solution 25ml 15mlChromogen Solution A 6.0ml 3.0mlChromogen Solution B 6.0ml 3.0mlStop Solution 6.0ml 3.0mlClosure plate Membrane 2 2User manual 1 1Sealed bags 1 1Note: 1. Standard concentration was followed by: 3200, 1600, 800, 400, 200, 100 pg/mL.2. If samples generate values ​​higher than the highest standard, please dilute the samples with Sample Diluent and repeat the assay.PRECAUTIONS1. Do not substitute reagents from one kit lot to another. Standard, conjugate and microtiter plates are matched for optimal performance. Use only the reagents supplied by manufacturer 2. Allow kit reagents and materials to reach room temperature (20-25°C) before use. Do not use water baths to thaw samples or reagents. 3. Do not use kit components beyond their expiration date. 4. Use only deionized 5. Do not remove microtiter plate from the storage bag until needed. Unused strips should be stored at 2-8°C in their pouch with the desiccant provided. 6. Use fresh disposable pipette tips for each transfer 8. Disumable plasma must be handled as potentially hazardous and capable of transmitting disease. Disposable gloves must be worn as potentially hazardous and capable of transmitting disease. Disposable gloves must be worn during the assay procedure, since no known test method can offer complete Assurance that products derived from Rat blood will not transmit infectious agents. Therefore, all blood derivatives should be considered potentially infectious and good laboratory practices should be followed. 9. All samples should be disposed of i 11. The Waste should be allowed to stand for a minimum of 30 minutes to inactivate the viruses before disposal. 11. Substrate Solution is easily contaminated 12. Abstrate B contain 20% acetone, keep this reagent away from sources of heat or flame. 13. Remove all kit reagents from refrigerator and allow them to reach room temperature ( 20-25 °C).REAGENT PREPARATION AND STORAGEWash Solution (1X) - Dilute 1 volume of Wash solution (20X) with 19 volumes of deionized or distilled water. Wash Solution is stable for 1 month at 2-8°C. ASSAY PROCEDURE1. Prepare all It is recommended that all Standards and Samples be added in duplicate to the Microelisa Stripplate.2. Add 50μl of Standard or Sample to the appropriate wells. Blank well doesn't add anyting.3. Add 100μl of HRP -conjugate reagent to standard Wells and sample wells except the blank well, cover with an adhesive strip and incubate for 60 minutes at 37°C.4. Wash the Microtiter Plate 4 times.Manual Washing - Remove incubation mixture by aspirating contents of the plate into a sink or proper Using a squirt bottle, fill each well completely with Wash Solution (1X), then aspirate contents of the plate into a sink or proper waste container. Repeat this procedure for a total of four times. After final wash, invert plate, Note: Hold the sides of the plate frame firm when washing the plate to assure that all strips remain securely in frame. Automated Washing - Aspirate all wells, then wash Essentials brushes to aspirate as much liquid as possible and set fill volume at 350μL/well/wash. After final wash, invert plate, and blot dry by hitting plate Er blanket until no moisture appears.5. Add chromogen solution A 50μl and chromogen solution B 50μl to each well. Gently mix and incubate for 15 minutes at 37°C. Protect from light.6. Add 50μl Stop Solution to each well. Color in the wells should change from blue to yellow. If the color in the wells is green or the color change does not appear uniform, gently tap the plate to ensure thorough mixing. 7. Read the Optical Density (OD) at 450 nm using A standard plate is generated by plotting the average OD (450 nm) obtained for each of the six standard concentrations on the单词First, calculate the mean OD value for each standard and sample. All OD Values ​​are subtracted by the mean value of the balnk well before result interpretation. Construct The standard To determine the amount in each sample, first locate the OD value on the Y-axis and extend a horizontal line to the standard curve. At the point of intersection, draw a vertical line to the 4. Any variation in operator, pipetting and washing technique, incubation time or temperature, and kit age can cause variation in result. Each user should obtain their own standard curve.5. Intra-assay CV (%) and Inter-assay CV (%) are less than 15%.6. Assay range: 100 pg/mL - 3200 pg/mL.7. Sensitivity: The minimum detectable dose of Human TGF-β is typically less than 100 Pg/mL.8. Cross-reactivity: This assay recognizes recombinant and natural Human TGF-β. No significant cross-reactivity or interference was observed.9. Storage: 2-8°C (Use frequently); six months (-20°C) ). 10. QUOTE READ ONH;

Cabinet

We are manufacturer of Cabinet in China, if you want to buy Wood Cabinet,Living Room Cabinet,White Cabinet,Modern Cabinet, please contact us. We sincerely hope to establish business relationships and cooperate with you.

1. European-style TV cabinets mostly like to use wood, low-key luxury. Such as mahogany, elm, pine, etc. Of course, the price of solid wood will definitely be more expensive.
2. At present, there are many types of TV cabinets, such as floor cabinet type, combined type, plate frame structure and so on. You can choose according to your own spatial structure and personal preference.
3. The TV cabinet can be said to be the most dazzling star furniture in the living room, which can reflect the personality, preferences and taste of the owner to a certain extent.

1. Emphasize functional design, simple and smooth lines, and strong color contrast, which are the characteristics of modern style furniture.
2. Extensive use of new materials such as tempered glass and stainless steel as auxiliary materials is also a common decorative technique for modern style furniture, which can give people a sense of avant-garde and unrestrained.
3. Due to simple lines and few decorative elements, modern style furniture needs perfect soft fitting to show its beauty. For example, sofas need cushions, dining tables need tablecloths, beds need curtains and bed sheets. Soft furnishings are the key to modern style decoration. There are many styles of modern and simple chairs, which are enough to meet everyone's diversified market needs.
4. No matter how big the office is, it must be spacious. There is no need for cumbersome decoration and excessive furniture, and the overall coordination of space and furniture is reflected to the greatest extent in decoration and arrangement. In terms of modeling, geometric structures are mostly used, which is the modern minimalist fashion style

Wood Cabinet,Living Room Cabinet,White Cabinet,Modern Cabinet

DELO SOFA , https://www.modernluxuryfurniture.com

Posted on